How do you slope a curved/arched roof extrusion??? Please help

[noprs7735256]

I am working with Revit 2015 and the simplest way to describe this is as follows:

I have built four walls. I selected roof extrusion, picked the plane, selected start-end-radius arc, set at 45 deg. and boom an arched roof.
now my problem: I want to elevate one end of the roof 10ft above the opposite end. Any ideas would be greatly appreciated..

Thanks.

[PijPiwo]

Something like this? You will not be able to do this by the roof by extrusion. Use mass or model in-place swept blend.

104097

[Revitaoist]

When it gets too complicated with compound arcs, I will just create the whole roof as a family.

[abrang70707157]

Hi.
I want to create a roof like this picture but I don't know how.
can anyone help me ???
Thanks a lot ...
104127

[david_peterson]

That appears to be a roof on a single plane. Just draw what you want and add a slope arrow.
Or draw a ref plane of the slope, set the work plane to the ref plane and create an in-place mass set to a roof category.
Just a thought.