Level reversed in sections

[boofredlay]

I have a model that whenever a section cut is made the 4th floor level designation is on the opposite side of the rest of the floors. See attached.
Any ideas why this is happening? This is a project I entered after the building was starting to be modeled.

Thanks.

104098

[DaveP]

Coincidentally enough, I just addressed this very issue in another thread over at the Revit Forum
http://www.revitforum.org/architecture-general-revit-questions/31379-beginner-greetings-query.html#post172805
Bottom line; when that Level was created, it was "drawn" in the opposite direction from the others.
I have occasionally had luck fixing this by Mirroring the Level about it's own middle point, but it's VERY risky as that WILL delete anything hosted on that Level (like all of your Walls)

[boofredlay]

Thanks Dave. That was my suspicion but wanted to confirm.

- - - Updated - - -

I am wondering if it is contributing to this issue in any way (which is still plaguing me).
http://forums.augi.com/showthread.php?167118-Split-Section-Drag-End-issue&p=1317521#post1317521