witoldw735918
2016-09-27, 02:53 PM
Hi
We are having issue with CW outermost mullions/ transoms
Do you know any solution for the setting out position of curtain mullion in Revit ? We have a case which should look like this :
104156
Is there any possible solution to change position of curtain wall mullion in x axis ( along CW panel length)?
CW mullion shall be partially covered by PCC panel in plan and section. Hope it is understandable.
Thx in advance
We are having issue with CW outermost mullions/ transoms
Do you know any solution for the setting out position of curtain mullion in Revit ? We have a case which should look like this :
104156
Is there any possible solution to change position of curtain wall mullion in x axis ( along CW panel length)?
CW mullion shall be partially covered by PCC panel in plan and section. Hope it is understandable.
Thx in advance