htlmv
2016-10-10, 06:04 PM
I'm sure others have/had this problem.
you create toilet room stalls out of extrusions but they are set to Specialty equipment in family categories. after inserting them in and try and generate elevations, the stalls walls hide whats behind them even though the cut plane is no where close to the wall (between the toilet and the stall wall). BUT when you change the family to a generic model, the elevations shown correctly. BUT when you tag generic stalls, no can do. but you can tag the SE.
any help?
Thanks,
Howard
you create toilet room stalls out of extrusions but they are set to Specialty equipment in family categories. after inserting them in and try and generate elevations, the stalls walls hide whats behind them even though the cut plane is no where close to the wall (between the toilet and the stall wall). BUT when you change the family to a generic model, the elevations shown correctly. BUT when you tag generic stalls, no can do. but you can tag the SE.
any help?
Thanks,
Howard