htlmv
2016-12-08, 07:00 PM
Coworker is working on a project that someone else started. "Wall-1" was mirrored and now that mirrored wall of "Wall-1" does not show the poche. If I copy/cut and paste then the poche is shown.
any ideas?
Thank you,
H
Something else...when I change the fill pattern from Solid to Ansi138, ALL walls change to Ansi138. I switch it back to Solid Fill, and half the walls become solid fill.
any ideas?
Thank you,
H
Something else...when I change the fill pattern from Solid to Ansi138, ALL walls change to Ansi138. I switch it back to Solid Fill, and half the walls become solid fill.