Cadventurer
2016-12-20, 07:05 PM
Lately AutoCAD has been acting up.
The issue is type doesn't appear on command line.
After I window a dxf. I specify a base point then I would like to move to 0,0 but nothing will show up in the command line.
Dead in the water at this point.
Any help would be greatly appreciated.
Thank you.
Issue resolved- 3dconnexion was doing an almost imperceptibly slow creep while using inventor.
Updated the drivers and this re-associated 3dconnexion with Autocad which perceived this as a constant application of the escape key.
The issue is type doesn't appear on command line.
After I window a dxf. I specify a base point then I would like to move to 0,0 but nothing will show up in the command line.
Dead in the water at this point.
Any help would be greatly appreciated.
Thank you.
Issue resolved- 3dconnexion was doing an almost imperceptibly slow creep while using inventor.
Updated the drivers and this re-associated 3dconnexion with Autocad which perceived this as a constant application of the escape key.