fillet selected polyline vertices

[biggeorgesrq]

would like to enter radius and then select particular vertices of polyline to fillet.

Not the whole polyline. the existing fillet command would work.

autocad 2017

thanks,

BIGGEORGE

[BIG-AL]

Needs a bit of code to basicly replace two picks, not sure I can see much advantage, but here is a solution. No code just method some one may have done this. My only help is that I have a enter F123 on command line and it auto sets the fillet radius to the value after the F "123" and then runs Fillet normal 2 picks. Will post other link.

Enter radius
Use a while so can repeat
Pick pline point
Draw a circle work out the two intersecting points pline - circle use vl-intersectwith
Erase circle
fillet pt1 pt2