diy Plotter print tray

[geofras106693]

I don't know where to put this...

we have a kip 700m but that doesn't really matter...

the problem is the print tray.

a couple of prints are ok, but when we make sets or multiple sets someone has to baby sit the machine, or we end up with prints all over the floor.

we're a small co. cant afford to have a person baby sit the machine

what has any one else done to handle this...

Pics would be nice

[dgorsman]

We usually put a table with a tray or fabricated "stops" at the edges to catch the output. If its too high it gets cut off at the knees. :mrgreen:

Could be worse though - at one office the prints would come off with a residual curl so bad that if you left it alone, after a couple of drawings the last one got sucked into the manual sheet feeder. And usually not straight in either.