upside down truncated cone floor?

[john84851]

Is it possible to do a floor in the floor command of this shape or would you have to mass it? I'm working on a church sanctuary with sloped and curved floor - 'an upside down truncated floor'. Thanks.
John

[sbrown]

You will make an inplace floor family. What I typically do is make a floor for the aisles first, these are typically "straight slopes" then I can uses these as the hosts for my seating and it will assume the slope. Nest I fill inbetween the aisles with a inplace sweep with the same profile as the sloped aisle floor.

[john84851]

Thanks so much, I'll give it a shot.