Ramps

[Clarence Worley]

Hello

(I am a basic Revit user, lots of courses, first project)

I'm having difficulty getting a concrete ramp to work, straight for a while then a curve at the bottom.

I have used a slab and then modified sub elements to lift the top of the ramp up. But this only does the gradient from top of ramp to the start of the curve. Whereas I would like the gradient to calculate all the way to the bottom of the ramp.

I have also tried to create a family profile of a rectangle and added a sweep. But I can't quite get this to work. Also with this, I have to define a width for the ramp and I am not quite sure of that yet so would like that to be a little flexible.

I would just like some advise if either of these are the ways I should persist with.

Or if anyone has any links to training videos for this.

Thanks