Curtain wall join with existing corner

[michael748541]

Hi everyone, I've used this board as a reference for a while, but have recently encountered a problem I can't find an answer to and am looking for some help. I have a condition where two existing walls meet at a 90 degree corner and new interior curtain wall connects with them, see attached image for reference. The curtain wall keeps joining to the center of the wall and not allowing for a clean 90 corner. I've tried the wall join command, editing the profile of the curtain wall, and changing it to not automatically embed without any luck.

I'm sure there something super simple that I'm missing, but if someone could point me in the right direction that would be really appreciated.

[damon.sidel]

When you say you tried to change it to not automatically embed, did you try "Disallow Join"?

If not, to disallow a wall joining, select the wall, hover over the end grip of the wall, right-click and choose "Disallow Join". Then you can position that end of the wall and it will not join to any other walls.

[michael748541]

I had done disallow join, but then none of the walls would join. Right clicking on the grip for the storefront worked perfectly though. Thanks so much for the help!

[damon.sidel]

Glad it worked!