eashwell751603
2017-09-29, 04:11 PM
Please see a DWG attached which has really confused me and 4 of my colleagues.
Really can't figure this one out.
Two machines, two separate drawing files and still the same result.
List the 4 lines, they all measure at 180 degrees in the X Y plane, but they obviously aren't... Drew vertical line using ortho, checked it is 90 degrees using list and measured the angle between the 4 lines, all 90 degrees.
If they're not parallel that can't be the case.
Z values are all 0, flattened more than once.
Truly baffled.
Really can't figure this one out.
Two machines, two separate drawing files and still the same result.
List the 4 lines, they all measure at 180 degrees in the X Y plane, but they obviously aren't... Drew vertical line using ortho, checked it is 90 degrees using list and measured the angle between the 4 lines, all 90 degrees.
If they're not parallel that can't be the case.
Z values are all 0, flattened more than once.
Truly baffled.