Greg Benson-Shettle
2018-02-04, 04:12 PM
Hi Revitiers,
Trying to create a stair where the first 6 risers have a decreasing width where there is a curved stinger and the remaining risers are in a straight section of equal width. The problem I've been trying to fix is that where the curved boundary meets the straight boundary a raised lip is being created when I need it to be as one continuous stringer.
106103 106104 106105
I have experimented with the stringer drawn with 2 straight line and also 2 arc but the result was the same.
Whilst I have listed this as a 2018 issue but I expect it applies to most recent or all versions.
Anyone have clues or further suggestions.
Any help much appreciated.
Trying to create a stair where the first 6 risers have a decreasing width where there is a curved stinger and the remaining risers are in a straight section of equal width. The problem I've been trying to fix is that where the curved boundary meets the straight boundary a raised lip is being created when I need it to be as one continuous stringer.
106103 106104 106105
I have experimented with the stringer drawn with 2 straight line and also 2 arc but the result was the same.
Whilst I have listed this as a 2018 issue but I expect it applies to most recent or all versions.
Anyone have clues or further suggestions.
Any help much appreciated.