westech2777268
2019-01-05, 10:28 PM
Greetings!
I'm new to Revit. I have a project were the walls are sandwiched like corrugated cardboard. So say a curved or straight wall needs to show the corrugation. And I would prefer if I could adjust the frequency of the corrugation.
Is this possible in Revit. See attached example.
Thanks
Max Webber
I'm new to Revit. I have a project were the walls are sandwiched like corrugated cardboard. So say a curved or straight wall needs to show the corrugation. And I would prefer if I could adjust the frequency of the corrugation.
Is this possible in Revit. See attached example.
Thanks
Max Webber