HELP!!! How to create U shaped stair in Revit 2015

[mattbond]

I'm trying to create a U shaped stair, as shown in the attached PDF, but cant get the create stair to fit the dimensions i require.
Any help would be greatly appreciated. 107188

[mattbond]

Is this something that cant easily be done??

[mattbond]

Is anyone able to help me at all? It would be greatly appreciated.

[Steve_Stafford]

Create a stair using the second Winder Stair option, then use Convert to create a Sketch Based Stair. Edit the Sketch to match your configuration more closely. You'll need to edit the stair type to clean up the stringer result. I'd probably eliminate the stringer entirely on the inside boundary. I don't have 2015 available and I don't recall if the winder option showed up later or not. A sketch based stair ought to be able to do much the same though. If you're using worksets then try doing it in a stand alone project file. There is a quirk with sketch based stairs and worksets that makes it nearly impossible to finish a stair properly.

[mattbond]

Fantastic, worked a treat. Thanks so much :)