Topo Problem

[Doug]

I am using importing a topo for the 1st time. Problem when I Label the topo the contours they are off by 10'-0".
I imported the dwg file into my site plan.
I then used the "Use Import" command under topo surface.
The topo looks reasonable close not an exact match to the Civil Engineer Dwg.
Then I used the label Contour Command and they are off 10'.

I must have something set wrong

Can't find it:banghead: any ideas?

Doug

[luigi]

Yeah, you need to go to the "Site Settings" under "Settings". You need to change the "Passing through elevation" to 10' higher (or lower) and your project will label correctly

[Doug]

Thanks!!!

Doug