yoshi204783229
2019-10-03, 05:41 AM
Hey all
Working on creating a fascia by sweep on a complex roof.
However I can't seem to figure out why I can't get the sweep to join nicely in the corner.
When I tried to create a similar shape with an in-place-mass, it worked but I would like to input the model as a fascia sweep.
Attached is a .rvt with the roof and sweep.
Hope someone can help me...
Any help would be much appreciated!
Working on creating a fascia by sweep on a complex roof.
However I can't seem to figure out why I can't get the sweep to join nicely in the corner.
When I tried to create a similar shape with an in-place-mass, it worked but I would like to input the model as a fascia sweep.
Attached is a .rvt with the roof and sweep.
Hope someone can help me...
Any help would be much appreciated!