Drone Images

[rmk]

I have a project that was flown with a drone.
the images were mistakenly done in the wrong coordinate system.
is there a way in Civil 3d of Map to convert those images to another coordinate system.
I need to convert from Mississippi East zone to Louisiana South zone

[Opie]

Do those two zones overlap? If not, you will probably need to look at your drone software to see if the coordinate zone is set correctly.

If they do overlap, you can use Map to attach the drawing set to the incorrect zone to a drawing set to the desired zone. Images found in the incorrect zone can then be queried through the mapwspace palette to get it transformed to the correct zone.

[rmk]

thanks Opie,
they do not overlap, they are in two different states.
I did use map to query in the images which transformed them properly.

[Opie]

I realize they are in two different states. However, with the toe of Louisiana being below Mississippi, I didn't know if your drone's coordinates thought they were just further south.