dylanyoungmandolin617614
2022-09-30, 04:32 AM
Hello again,
I'm not sure what's happening here, I was printing elevations (with hatches) to pdf ok up until now. I get a msg that says even though Mass is enabled, it may not show up? I've been all over the VG but to no avail, thank you much. Dallas
I'm not sure what's happening here, I was printing elevations (with hatches) to pdf ok up until now. I get a msg that says even though Mass is enabled, it may not show up? I've been all over the VG but to no avail, thank you much. Dallas