chris.harmon682006
2023-04-11, 09:56 PM
Hey All!
This has me at the end of my rope.... I have a structural beam system of dimensional 2x12s @ 16" o.c. being supported by 6x10 timber beams supported by 6x6 timber columns. The top of my beam elevation and the bottom of my joist elevation are identical and Revit for some stupid reason is cutting the joists back to the midpoint of the timber beam. I've tried separating the two by 1/16" and no change.... why can't us perfectionists have our cake and eat it too?!?!?!?!? Any advice would be GREATLY appreciated!!!!
Thanks in advance!
MT
This has me at the end of my rope.... I have a structural beam system of dimensional 2x12s @ 16" o.c. being supported by 6x10 timber beams supported by 6x6 timber columns. The top of my beam elevation and the bottom of my joist elevation are identical and Revit for some stupid reason is cutting the joists back to the midpoint of the timber beam. I've tried separating the two by 1/16" and no change.... why can't us perfectionists have our cake and eat it too?!?!?!?!? Any advice would be GREATLY appreciated!!!!
Thanks in advance!
MT