doors not showing up

[cboisvert]

i'm doing a project with about 300 doors and i can't get a couple of the doors to show up. the tag is visible, and even the flip arrows are showing so i know they're there. i just can't figure out how to make them show.

[beegee]

Is it possible your cut plane could be above the door head ? ( the tag will still show in most cases )

If not, check the door familie's symbolic line visibility.

[Steve_Stafford]

i'm doing a project with about 300 doors and i can't get a couple of the doors to show up. the tag is visible, and even the flip arrows are showing so i know they're there. i just can't figure out how to make them show.Copy and paste the wall hosting these doors into a fresh project along with another wall that is working. Make sure the doors come along and then post that smaller project here so someone can take a look...if you can...

[cboisvert]

beegee
you were right, it was only the cut plane. i thought it was on 4' because thats what i always leave it on. apparently it had been changed by somebody else without my knowledge. when i set that to 4'-0" my doors appeared. thanks