Doors not showing in Plan Regions

[bowlingbrad]

Linked central file into an empty project.

Can't get plan region to show doors. I tried all different values for the depths, bottom, top...
If I delete the region and change the view range of the entire view, the door shows up :screwy:


Any thoughts?

[funkman]

All of a sudden.....a couple of my walls are not showing up in plans using the plan region tool. I am sure they were there yesterday!!

If I delete the plan region, they are there again. Any ideas on this?

[beegee]

Is it possible that you have the bottom plane of the primary range and the view depth set above the wall ?




All of a sudden.....a couple of my walls are not showing up in plans using the plan region tool. I am sure they were there yesterday!!

If I delete the plan region, they are there again. Any ideas on this?

[beegee]

Is the plan region picking up the correct datum ?

Try setting the Top to " Unlimited" and the Cut Plane to " Parent View's Level"


Linked central file into an empty project.

Can't get plan region to show doors. I tried all different values for the depths, bottom, top...
If I delete the region and change the view range of the entire view, the door shows up :screwy:


Any thoughts?

[funkman]

Try setting the Top to " Unlimited" and the Cut Plane to " Perent View's Level"that was it!!
thanks beegee
I thought it was unusual that in the same plan region, two walls werent showing but the others were ok even on the same floor level. Bizarre.