photography67836
2005-05-17, 07:09 PM
Hi group,
Our project currently shows the base elevation at 0" or 0'-0". However I need to show that same elevation at 100'-0". I cannot afford to physically move the entire project (with all the referring details, sections, etc). Is it possible to just alter the global elevation so that the elevation/level lines show 100'-0" in additional to the level that is currently showing? Or is there another method to achieve this?
Thanks.
Our project currently shows the base elevation at 0" or 0'-0". However I need to show that same elevation at 100'-0". I cannot afford to physically move the entire project (with all the referring details, sections, etc). Is it possible to just alter the global elevation so that the elevation/level lines show 100'-0" in additional to the level that is currently showing? Or is there another method to achieve this?
Thanks.