A3D
2005-05-29, 04:11 PM
Hi everybody,
I have a very strange problem - I looked for it in the forums, but after a while I stopped searching.
I made a Wall based generic family. Inside this family I set a few objects to display or not depending on the detail level.
When I insert the family in the wall, everything is there.
BUT, if I join this family with the host wall, the objects that were supposed to display on the fine detail level disappear.
Unjoinning the family from the wall won't bring them back; I tried opening again the drawing, reloading the family ,etc. - no way. The objects which supposedly display on fine level detail are gone.
Thank you
I have a very strange problem - I looked for it in the forums, but after a while I stopped searching.
I made a Wall based generic family. Inside this family I set a few objects to display or not depending on the detail level.
When I insert the family in the wall, everything is there.
BUT, if I join this family with the host wall, the objects that were supposed to display on the fine detail level disappear.
Unjoinning the family from the wall won't bring them back; I tried opening again the drawing, reloading the family ,etc. - no way. The objects which supposedly display on fine level detail are gone.
Thank you