make acad back to default

[RCA4697]

hello guys, me again, how can i make 2005 LT. back to default setting. (all) without uninstalling the program. is there a way? thanks!

[Mike.Perry]

Hi

Within the Options dialog box, does AutoCAD LT have the Profiles tab?

If yes, go to that tab and take a look at the "Reset" button (right hand side).

Have a good one, Mike

[RCA4697]

no it does not have the profile tab.

[Mike.Perry]

no it does not have the profile tab.Hi

Then, pass... hopefully an AutoCAD LT user will pop along and post a workable solution.

Have a good one, Mike

[tyshofner]

I'm not sure that there is an easier way than just re-installing. What I have done in the past to keep a "default" setup for LT is just make a backup copy of the LT registry entry. I know that in LT there is a "profile", but the only way you can access it is through the registry. It will normally be called "unnamed profile", right after the software has been installed, just export that reg key and you can use it to set ACLT back to default. Unfortunately this has to be done before you have made any changes to ACLT. Wish I could help you more, but you'll probably just have to re-install this time.

Ty :mrgreen: