Cantilever beam in R8 doesn't work with wall.

[Alvin_Alejandro]

I'm trying to clean the corner of cantilever beam.
Without wall it works nicely but when I add brick wall the corner of the beam separate, both beams above & below...


-Alvin

[Shaun v Rooyen]

Alvin this was quite strange! If I used the pick wall tool and did it in 3D view, the beams ended up like yours. untidy.
I then went to plan view and sketched the walls as normal and no problem?????????
Here is your fixed file. Go figure?

[Alvin_Alejandro]

Thanks Zeds, I got the solution...I created a beam family which allow me to adjust the end of beam.