Level Discrepancy (was>Help needed)

[tarch]

I have 1-1/8" dimensional discrepancy between floor to floor dimension and level heights. I suspect it comes as the result of raising the building by aproximately 24" after Project Relocation but can't figure out how to fix it. If I make levels shared, discrepancy disappears.

[beegee]

Have you tried to relocate your project again - this time 1 1/8 " lower ?

[tarch]

Have you tried to relocate your project again - this time 1 1/8 " lower ?I have but couldn't achieve second floor elevaton to be 13'-0" without moving whole building. I'm still puzzeled with 1 1/8" difference which in my opinion shouldn't be hapening regardless what I did or didn't do, 102 + 11 should always add up to 123.

[daniel.hurtubise70031]

102 + 11 should always add up to 123
113 ? maybe

[tarch]

102 + 11 should always add up to 123
113 ? maybeRight, should have used calculator. Brain obviously isn't functioning at 40+ degrees here in Toronto.

[beegee]

If you relocate the project 1 1/8” lower, the shared levels should then read :-


Second Floor 113’ 0”

First Floor 101’ 10 7/8”.


Correct ? ( This assumes that you have the Level Properties set to Shared and you have dimensions constraining the levels )

If so, you would then adjust the First floor level to 102’ 0” ( remove the dimesion constraint first ) and adjust the Basement level also if necessary.

[tarch]

If you relocate the project 1 1/8” lower, the shared levels should then read :-


Second Floor 113’ 0”

First Floor 101’ 10 7/8”.


Correct ? ( This assumes that you have the Level Properties set to Shared and you have dimensions constraining the levels )

If so, you would then adjust the First floor level to 102’ 0” ( remove the dimesion constraint first ) and adjust the Basement level also if necessary.That's exactly what I did B, thanks.