Davied2
2005-06-17, 01:34 PM
Hi Guys
Your help is required yet again please.
I have taken one of Revit 8's standard I beams and want to place circular voids in the steel beam so services may pass through - however, I want to make these circular holes at 540mm centres along the length of the beam. (A cellular beam I think its called).
Ideally it would be clever for some form of calculation that would add/remove holes when the length of the beam is changed.
Has anyone every tried this before or have an example I could use.
Many thanks
David
Your help is required yet again please.
I have taken one of Revit 8's standard I beams and want to place circular voids in the steel beam so services may pass through - however, I want to make these circular holes at 540mm centres along the length of the beam. (A cellular beam I think its called).
Ideally it would be clever for some form of calculation that would add/remove holes when the length of the beam is changed.
Has anyone every tried this before or have an example I could use.
Many thanks
David