What's up with this wall sweep?

[patricks]

I have a wall type defined as a CMU wall with a pre-cast concrete cap that runs along the top (for a low "knee wall" of sorts). The problem is that the sweep isn't turning corners properly. See my attached image below.

The LEFT corner shown actually has the corner condition set to MITER, yet the sweep doesn't turn the corner properly.

The RIGHT corner shown actually has the corner condition set to BUTT, yet the sweep DOES turn the corner properly. What's the deal here?

[sbrown]

are the exterior faces of the wall on the same side. If one wall is flipped wrong this will happen.

[patricks]

Nevermind, must have been an issue with a previous version. I just blew the walls away and re-created them and it all came out correctly.