patricks
2005-06-17, 07:06 PM
I have a wall type defined as a CMU wall with a pre-cast concrete cap that runs along the top (for a low "knee wall" of sorts). The problem is that the sweep isn't turning corners properly. See my attached image below.
The LEFT corner shown actually has the corner condition set to MITER, yet the sweep doesn't turn the corner properly.
The RIGHT corner shown actually has the corner condition set to BUTT, yet the sweep DOES turn the corner properly. What's the deal here?
The LEFT corner shown actually has the corner condition set to MITER, yet the sweep doesn't turn the corner properly.
The RIGHT corner shown actually has the corner condition set to BUTT, yet the sweep DOES turn the corner properly. What's the deal here?