Fascia trimming @ gable end

[christo4robin]

Is there a way to have the fascia tool trim this as I sketched? I'm thinking my fall back is generic model voids to "cut" these puppies off.

Thanks!

[christo4robin]

The sketch helps...

[christo4robin]

Just attempted the void solution. Didn't work - Revit doesn't seem to like cutting a void into a fascia.

[sbrown]

I make all my gable fascias with an extrustion family that is adjustable slope, thickness, pork chop, etc. Just make on to suit your needs then bring it in a copy it around.

[msmith.tsap]

Old post but current problem. How do you make this work. Do not understand how you resolve the issue at the eave/rake juncture. Rake angle causes triangular portion show is previous post in thread. Still buffalo'd.

Marc
TSAP