Creating a roof between points

[rgranja508683]

Hi,

I need to know if it's possible create a roof between this six point?
I try using the slope Arrow but without any result, any suggestions?

[beegee]

Make the roof as an in-place blend.

[Dimitri Harvalias]

Ricardo,

There may be a better way but the easiest solution is to create an in place roof blend (or two blends, one for each side). If created as a roof you can then attach the walls to the underside of the roof.

[rgranja508683]

The problem is that the two walls that have the slope are not parallel.
See the example attached.

[Henry D]

There are probably many ways to do this roof. What I did is made an extruded roof and then used void extrusions to cut out the overhangs so they were parallel to the walls. Hope this gives you some ideas.

[Wes Macaulay]

Check out the attached solution.