Crosshairs do not display in Modelspace

[minhtct]

Hi everyone

I have problem with the cross hair. It does not show up in model space. When I go to paper space it works ok. Is there a setvar for that?


Thanks for your help.

Mkt

[bbapties]

go in options under the display tab and make sure somebody hasnt changed the color of the modeltab pointer to the same color as background...:twisted:

[Wanderer]

Hi everyone

I have problem with the cross hair. It does not show up in model space. When I go to paper space it works ok. Is there a setvar for that?


Thanks for your help.

Mkt
I'm going to move this from the CAD Mgmt forum, as I believe it will be better served here.

Thanks.

[David.Hoole]

Another possibility is that grid snap is on, and you are zoomed in to a point where no grid nodes are visible. Came across this a couple of years ago and it took a while to figure out!

[madcadder]

go in options under the display tab and make sure somebody hasnt changed the color of the modeltab pointer to the same color as background...:twisted:
That has the potential of being a great prank!

[Rico]

That has the potential of being a great prank!
yeah, i suppose it does! :lol:

[bbapties]

that is why I suggested to check it....It's happened to me.

[caddict]

Thanks for the tip! My ABS 2006 tutotial has the Layout Tab pointer set to the layout background color. It was driving me crazy!

Thanks again,
Rich

[wmsadmin]

lol,

Dood ole search funtion, sorry to bring up an old thread, but I just had the same problem,

After spending about 2 hours updating BIOS, display drivers, and trying to recover files, googe searchiing anything I could find, and almost resorting to pulling out what little hair I have, I found that the snap was on and I was zoomed in too far to see. What can you do eh?

What a good way to start a Friday!