Fatal Error when trying to Open a drawing file.

[Khusanov90973]

Dears,

After buzzed render, I cannot open my dwg.file. The system informs about a fatal error (Unhandled Access Violation Reading 0xe170000 Exception at 63997292h).

Please anybody who knows the error, what should I do to fix the problem. I had been working under the file about a week...

I am ready to pay for your assistance, if it principle.
Thank you very much in advance for your assistance!

Regards,
Rustam

[Mike.Perry]

Hi

For starters have a browse of the following thread (take note of all links within) -

Unable to Open a drawing file (http://forums.augi.com/showthread.php?t=22144)

Have a good one, Mike

[rkmcswain]

Dears,

After buzzed render, I cannot open my dwg.file. The system informs about a fatal error (Unhandled Access Violation Reading 0xe170000 Exception at 63997292h).

Please anybody who knows the error, what should I do to fix the problem. I had been working under the file about a week...

I am ready to pay for your assistance, if it principle.
Thank you very much in advance for your assistance!

Regards,
Rustam
Have you tried:
+ Using the RECOVER command?
+ Inserting the bad drawing into a new empty drawing?
+ Using DesignCenter to recover parts of the bad drawing?
+ Using a Map Query to recover parts of a drawing? (if you have Map)
+ Using IntelliCAD to open the drawing?
+ Using Microstation to open the drawing?
+ Using Batch Drawing Converter to save the drawing to another version?
+ lastly.... check out http://www.intelcad.com/pages/dwgfix/index.htm

Good luck