Walls sweeps at the end of a wall

[hdjohnson]

I've drawn a typical 8" concrete wall. I want to add a revel to it; however, I'm only allowed to add it to the sides of the wall not to the end of it. Is there a way around this, or do I have to draw two 4" walls together? Please advise.

[beegee]

I usually add a wall, on the end, cut the reveal and then join geometry.

You could also try an in-place void to cut the wall.

[hdjohnson]

Thanks, beegee.

[LMSmith]

You can also use the "Change Sweep Returns" button on the options bar. Select the reveal, hit Change Sweep Returns, and specify the angle to be
-90° (or similar - it's just important that it's negative to go into the wall).

[hdjohnson]

You can also use the "Change Sweep Returns" button on the options bar. Select the reveal, hit Change Sweep Returns, and specify the angle to be
-90° (or similar - it's just important that it's negative to go into the wall).

Thanks LMSmith. That'll certainly do the trick. Thank you.