Existing wall fill

[sfaust]

I would like my existing walls to display without a hatch for clarity. I have gone to the materials settings and changed the cut properties for the "phase-exist" material to be solid fill white. This works quite well in section, but for some reason it still displays the hatches in plan. Am I missing something?

Thanks,
Steve

[beegee]

Check that under Settings>Phases>Graphic Overides, the material for Existing is set to "Phase Existing"

[sfaust]

Thanks, I checked that, though. I just did figure it out. In the Settings>Phases>Phase Filters tab, "existing" was set to "By Category" instead of "Overridden" in the "Show Complete Category. Chalk that one up to learning...

Steve