DWG and Image have different Coordinate Systems, what to do?

[dpelletier]

I have survey data in a DWG in State Plane and I have an image in UTM.
I want to have the image behind my survey data.
I have read a few posts on attaching and querying, but I am not fully clear on it. Been spending some time trying to figure it out, and it's not working out.
My concern is I don't know any common points that the 2 have. I wasn't in the field collecting this information, and the people that were want to see how this data looks over an image.
Any one have any suggestions?

Thanks
Dennis

[Glenn Pope]

Did you look at this thread?

Combine files with different coordinate systems (http://forums.augi.com/showthread.php?t=17193&p=107733)

[dpelletier]

Not that one, but seen a few that descibe things like it.
I guess my guestion is when you say "run query".....I am confused.
What is the query I need to enter?

[Glenn Pope]

You could just do a simple location all query. This will pull in everything from each attached drawing.