Can both fascias be vertical

[Alek Sutulov]

My roof shall consist of series of twisted surfaces as seen on attached image. At corner conditions I can't make fascias meet at 90 degrees with respect to floor. If I make 2 individual sweeps, I can't make a clean trim where they meet. If the sweep runs along continous path, then only the first path segment is vertical.
Any suggestions?

[Steve_Stafford]

Hosted sweeps will probably not work any differently than you see now...but you might have better success with an inplace family swept along the roof edges. Worth a try.

[LMSmith]

Sweeps won't work well in this case. Try this: duplicate your blend, make it a little bigger (the width of the fascia), duplicate another blend, transform it to a void (in properties) and use it to cut the middle out of the fascia blend (like a donut). Not very intuitive, but it works! (BTW, I put your old fascia in a secondary design option - nice way to hide things)

[Alek Sutulov]

Thanks guys.

[JamesVan]

Thanks guys.

...or GALS, as the case may be!