Can't seem to move a Model Pattern on a curved wall?

[hdjohnson]

I have a curved wall that has a 6'-0"x4'-0" model pattern attached to it. I can move the pattern up or down, but I can't move the pattern left or right. I'm trying to line up the patter with a curtain wall assembly, but can't seem to do it.

I made a straight wall with the same wall type and I'm able to move and rotate the pattern. However, I can't move (except up or down) or rotate the pattern on a curved wall.

Any suggestions?

[E-Key]

Try to split the wall at the point where you want to start vertical line of pattern.

[E-Key]

There is another way to do that. Don't use MOVE command. Just drag and drop vertical line of the pattern.

[hdjohnson]

I can't seem to drag and drop the line to the new location. I can't move the lines left or right.

[bclarch]

Have you tried using the "align" tool instead of moving? Can't guarantee that it will work but its worth a shot.

[E-Key]

I can't seem to drag and drop the line to the new location. I can't move the lines left or right.I believe you are trying to drag on short distance. Try to drag for more longer distance.

[hdjohnson]

I believe you are trying to drag on short distance. Try to drag for more longer distance.


Thanks that worked!