Dimension line tick marks?

[m_r_meza]

I am trying to figure out how to adjust the appearance of the tick marks of a dimension line. I would like to adjust the 1/8" tick mark so that it is squared off at the edges and a bit shorter that 1/8". I realize that one can adjust the line thickness in the properties menu. Any suggestions?

[Paul P.]

Try under Settings, Annotations, Arrowheads. Then you can duplicate the existing tick mark and change the size of it to whatever you want. Hope that helps.

Regards, Paul.

[BWG]

Try under Settings, Annotations, Arrowheads. Then you can duplicate the existing tick mark and change the size of it to whatever you want. Hope that helps.

Regards, Paul.

I think he might want to change the angle as well, which it is greyed out. Would be nice if we could change this.

[Paul P.]

Agreed, that would be useful, but at least he can reduce the size. Not a complete solution but half way there.

Paul.