Tom Weir
2005-08-24, 04:56 PM
Hi all,
I have a linked Revit file that represents the existing structure in the file where I am adding a new addition. When I use the "halftone" parameter to tone the existing linked model it prints very very light, barely shows up on the paper. I tried adjusting the line weight thickness but that did nothing.
So I thought I would use a phase override. But it does not seem to have an effect on the linked RVT.
Any suggestions would be greatly appreciated...
Tom Weir
Los Angeles
I have a linked Revit file that represents the existing structure in the file where I am adding a new addition. When I use the "halftone" parameter to tone the existing linked model it prints very very light, barely shows up on the paper. I tried adjusting the line weight thickness but that did nothing.
So I thought I would use a phase override. But it does not seem to have an effect on the linked RVT.
Any suggestions would be greatly appreciated...
Tom Weir
Los Angeles