ROOF JOIN QUESTION

[wse1]

When I join two gable roofs at 90 deg. to one another, the roof to be joined hits the target face and correctly creates a valley. However, the facias don't seam to join correctly in that the facia joins to the diagonal line of the valley and not perpendicular to the target facia as shown in the attached file. Is there a setting or technique required to join roofs and facias together. What am I missing here?

Any ideas or suggestions are greatly appreciated!

Thanks Bill

[beegee]

Try deleting the fascia then recreate after the two roof are joined.

You could also try doing the roof as one roof rather than two.