Section Views

[max]

I tried to find an answer by doing a search, but had no luck. I am trying to get more than one Section with the same reference numbers on the foundation plan. Say you have a cut through the foundation and you want to show this section cutting more than one wall, but have only one detail since it is typical.

I am not sure I am saying this correctly.
Thanks

[christopher.zoog51272]

I tried to find an answer by doing a search, but had no luck. I am trying to get more than one Section with the same reference numbers on the foundation plan. Say you have a cut through the foundation and you want to show this section cutting more than one wall, but have only one detail since it is typical.

I am not sure I am saying this correctly.
Thanks
when you go to place you section mark, look at the options bar. Check the box that says "ref this view" and select the section or detail that you want it to reference, in the pull down. That's about it.

HTH,
Z

[max]

I should have known it would be simple. Thanks Chris!