Wall Join Angering Me

[jamesd10181097]

Figures these walls were joining just fine until now the day before the project is due.

I am not sure what has caused these walls to stop joining smoothly but it is really frustrating me. I have tried edit wall joins, tried pulling the walls back then trimming them together again. I am at my wits end. I would just leave it but it makes my elevation look horrible.

Please help

[jamesd10181097]

Sorry wrong image

[tamas]

Could you cut and paste the offending corner into a small rvt file and post it here for us to take a look?

Thanks,

Tamas

[m_r_meza]

I have noticed that sometimes when walls are different heights they don't join properly. This has happened to me when a wall is becoming a parapet above and joining to a wall that does not protrude the roof. I have resorted to creating walls that are the same height and creating a different wall for the parapet. This does not always happen, but sometimes for some reason it does.

[jamesd10181097]

When I created the other file to post the walls join fine in that file. So it must be another element in the project that is disturbing the wall join.

[Wes Macaulay]

Absolutely. It could be a floor or a roof, too...

[jamesd10181097]

I can't believe it. It was a room separation line. Apparently someone did not think the walls were enough to define the the boundary of the room.