DDbyBobW
2005-09-09, 10:57 PM
When placing a Structural Column in 8.1 and then viewing the Column Properties I cannot select the options under Graphics to show Top Connection Symbol or Base Plate Symbol.
In 8.0 I can place a Structural Column and in Properties under Graphics check Weld Connection and Plate Connection and they show in elevation. I can schedule the Base Plates. How do I do this in 8.1?
Thank you,
Bob W
In 8.0 I can place a Structural Column and in Properties under Graphics check Weld Connection and Plate Connection and they show in elevation. I can schedule the Base Plates. How do I do this in 8.1?
Thank you,
Bob W