vtmiii
2005-10-10, 10:25 PM
dose anyone know why when inserting blocks and you change the x and y size, the block assumes the x size for the z size. example i have a block called RTD, its created on layer 0(zero) (that is was done that way so we can use the block for return air duct and a existing havc layer) the block was created as a 1x1 block. So if i insert the block
give the x as 24 inches and y 18 inches and then hit enter after rotating it, it will assume the 24 for z. the z should remain default , which is 1.
give the x as 24 inches and y 18 inches and then hit enter after rotating it, it will assume the 24 for z. the z should remain default , which is 1.