Frieze Board

[Les Therrien]

Hey All,

I didn't find anything in the search, but what I need to create is a frieze board in a gable. I cannot remember how this was done. Please refresh my memory!!! :?:

[christopher.zoog51272]

Hey All,

I didn't find anything in the search, but what I need to create is a frieze board in a gable. I cannot remember how this was done. Please refresh my memory!!! :?:


Use the fascia tool, select the lower edge of the gable, and set the horizontal offset to the distance of your overhang. :)

hth

[Les Therrien]

I knew there was an easy way!

Thanks Chris. Leave it to you to answer the posts that nobody else will answer.
Cheers! 8)

[adegnan]

How about this?? Two problems. I can't use a fascia roof host sweep. I can't figure out how to do it in place as a sweep either. DO I need to do a bunch of extrusions?

Thanks!

[Yman]

I can't get them to clean up either. A person could make a family and be able to do it that way. I would do it with in-place families if I had to turn the corner. Or if you use corner boards then you can place roof fascia's independently.

Y

[adegnan]

Corner board would work on the left, siding example (another detail to add!) but on the brick area at the right, corner boards will not work.