crop region BIGGGGG

[fernando]

i notice this problem since using Revit 6 build 20031217_2330

some times my crop region gets a size of something like 471493mm x 291mm (the value varies)
it happens in the floor plans , and in the 3d views
wich is a hard work to correct the size of the crop region

in the 3d view i notice that the camera position and the pivoting point came out of my model wich get me with a hard time to se anything

is this a bug? of 6?

[sbrown]

This usually has to do with the insertion of a dwg with data that is far away from your model, revit selects the center of ALL geometry as the rotation point, so turn off all dwgs then check again.

[Les Therrien]

this has happen to me and it's not limited to when I insert .dwgs
I had one that made my elevations 20000ft tall.

I guess I was building on Mars.

[fernando]

the last time it happens to me it was after some floor sketching
when i go to 3dview my model was very small, and the camera position is something out of view
(no dwg insert)

[contact1813]

I Have also seen this, I noticed the Reference Plane Lines were streched out of the expeted view Range. Or a imported Text Note Box was extended too far.