artitech
2005-10-20, 03:47 PM
We are trying to have Revit calculate the amount of cut and fill for a project and when we try to create the graded subregion it isn't following all the elevation points that we placed on the site, see attached image showing what is happening.
All the black points that you see are at the same elevation, yet Revit is connecting across the area shown in a straight line rather than following it along the contour that we are creating with the points. We are therefore not getting an accurate value for the cut and fill material.
(I'm not the one in our office that is working on this particular site so I hope I am clear enough on the problem we're experiencing).
Is this familiar to anyone?
All the black points that you see are at the same elevation, yet Revit is connecting across the area shown in a straight line rather than following it along the contour that we are creating with the points. We are therefore not getting an accurate value for the cut and fill material.
(I'm not the one in our office that is working on this particular site so I hope I am clear enough on the problem we're experiencing).
Is this familiar to anyone?