Things that don't work as well anymore

[narlee]

Have you noticed (and I wish the factory would go back and fix rather than add new features):

1) Changing an edited wall profile often requires you to completely remove the sketch and start over or you get a message about invalid profile that will not let you continue.
2) In-Place family extrusions that you want to adjust, but unless you wipe out the entire sketch, Revit thinks there's an extra line in there.

[lev.lipkin]

Please post examples here or provide them through support. Factory is not aware of both issues.

[MRV]

I don't think I've EVER had either one of those happen to me.

Michael

[hdjohnson]

I haven't had these problems either. Maybe you should send the file to support ....

[SkiSouth]

I've still got a problem with roof sketches and Revit's logic since 7.0

[BillyGrey]

I've had 1) happen to me.
Also, I've had problems just moving walls with profiles, that are stacked over or adjacent to other walls.

[Roger Evans]

I've still got a problem with roof sketches and Revit's logic since 7.0

With roofs ? or in General Ski ?

[SkiSouth]

Got to watch out for that British humor.... :screwy: :grin: :grin: The roof logic. Revit solves the roof ridge/valleys correctly, but I've found it not cooperative in the solution I want it to go to . (Need some type of toggle IF the factory will not go back to the 6.1 logic.) See this thread (http://forums.augi.com/showthread.php?t=19260&highlight=roof)

[BWG]

Another post on here a few weeks ago stated they have fixed the roof problem, but it did not make the 8.1 deadline.